反应 #72408

反应方程式

ethyl 7-cyclopropylheptanoate

ammonium chloride

cyclopropylmagnesium bromide

NaOH

ethyl 7-iodoheptanoate

→

7-cyclopropylheptanoic acid

收率 40.0%

溶剂

water

THF

THF

THF

反应条件

后处理

1. 1
   其他equipped with a Teflon-coated magnetic stirring bar
2. 2
   其他The flask was evacuated
3. 3
   温度while being heated
4. 4
   其他purged with argon from the balloon
5. 5
   workup.ADDITIONbefore addition of any reagents or solvents
6. 6
   workup.ADDITIONAfter the addition
7. 7
   workup.ADDITIONAfter the addition
8. 8
   workup.STIRRINGstirred for 2 h
9. 9
   温度to warm to ambient temperature
10. 10
    workup.STIRRINGstirred overnight
11. 11
    萃取The organic product was extracted into an ether layer which
12. 12
    洗涤was washed with brine
13. 13
    干燥dried over magnesium sulfate
14. 14
    过滤filtered
15. 15
    浓缩concentrated in vacuo
16. 16
    其他to yield a residue
17. 17
    workup.STIRRINGThe mixture was stirred at ambient temperature overnight
18. 18
    洗涤The alkaline solution was washed with ether
19. 19
    其他The aqueous layer was separated
20. 20
    其他subjected to in vacuo evaporation
21. 21
    其他to remove any residual ether
22. 22
    其他leading to the precipitation of a white solid
23. 23
    workup.STIRRINGStirring
24. 24
    workup.WAITwas continued for an additional 30 minutes
25. 25
    过滤the precipitate was filtered off with suction through a sintered glass funnel
26. 26
    洗涤The collected solid was successively washed with water and two-50-ml of hexane
27. 27
    其他was dried in vacuo at room temperature for 2 days

实验过程

All reactions reported in this example were carried out in an oven-dried three-necked, round-bottomed flasks equipped with a Teflon-coated magnetic stirring bar, copper iodide and a T-joint to which an argon-filled balloon had been attached. The flask was evacuated while being heated, then purged with argon from the balloon. This operation was repeated three times before addition of any reagents or solvents. To a stirred suspension of cuprous iodide (2.38 g, 12.5 mmol) in 30 mL of dried THF at ca −78° C. under argon, cyclopropylmagnesium bromide in THF solution (0.5M, 50 ml, 25 mmol) was added via syringe. After the addition had been completed, the mixture was stirred for 30 min and a solution of ethyl 7-iodoheptanoate (3.02 g, 10.63 mmol) in 10 ml of THF was added. After the addition, the reaction was allowed to warm to 0° C. and stirred for 2 h. It was allowed to warm to ambient temperature and stirred overnight. The reaction was poured into a saturated ammonium chloride solution. The organic product was extracted into an ether layer which was washed with brine, dried over magnesium sulfate, filtered, and concentrated in vacuo to yield a residue. 1H NMR confirmed the desired ethyl 7-cyclopropylheptanoate. GC indicated a single peak material. To the residue were added 25 mL of water and a 25 ml of a solution of NaOH (2N). The mixture was stirred at ambient temperature overnight. The alkaline solution was washed with ether. The aqueous layer was separated and subjected to in vacuo evaporation to remove any residual ether. The alkaline solution was acidified with an aqueous solution of HCl (2N) leading to the precipitation of a white solid. Stirring was continued for an additional 30 minutes and then the precipitate was filtered off with suction through a sintered glass funnel. The collected solid was successively washed with water and two-50-ml of hexane, and was dried in vacuo at room temperature for 2 days to afford 0.72 g (40%) of 7-cyclopropylheptanoic acid as a white solid. 1H NMR (400 MHz DMSO-d6) δ: 0 (m, 2H), 0.37 (m, 2H), 0.66 (m, 1H), 1.16-1.18(m, 2H), 1.34-1.50 (m, 6H), 1.78 (m, 2H), 2.20 (m, 2H), 12.0 (s, 1H). 13C NMR (100 MHz DMSO-d6) δ: 4.27, 10.65, 24.50, 28.61, 29.05, 33.64, 34.01, 174.43. Anal. Calcd for C10H18O2: C, 70.22; H, 10.66. Found: C, 70.05, H, 10.34 with a Karl Fisher water content %: 0.46.

来源