反应 #684973

反应方程式

diisopropylamine

phenyllithium cyclopentane diethyl ether

tetrahydrofuran

tetrahydrofuran

sodium thiosulfate

ammonia

ammonium chloride

hydrogen peroxide

→

title compound

2-Chloro-3,4-dimethoxypyridine

溶剂

ethyl acetate

acetic acid

反应条件

后处理

1. 1
   workup.WAITat −18° C. for another 20 minutes
2. 2
   温度The reaction mixture was cooled again to −78° C.
3. 3
   workup.STIRRINGthe resulting mixture was stirred at 0° C. for 20 minutes
4. 4
   workup.STIRRINGthe mixture was stirred at room temperature for 2 hours
5. 5
   洗涤the mixture was washed with saturated brine
6. 6
   其他The ethyl acetate layer obtained upon filtration through silica gel
7. 7
   浓缩was concentrated under reduced pressure

实验过程

A solution of diisopropylamine (84.0 μl, 0.599 mmol) and the compound of Example B240 (860 mg, 5.99 mmol) in tetrahydrofuran (4 ml) was added to a solution of 1.06 M phenyllithium cyclopentane-diethyl ether solution in tetrahydrofuran (11 ml) cooled to −78° C. under nitrogen atmosphere. This reaction mixture was stirred at −40° C. for 1 hour, then at −18° C. for another 20 minutes. The reaction mixture was cooled again to −78° C., trimethoxyborate (2.04 ml, 18.0 mmol) was added dropwise thereto, and the resulting mixture was stirred at 0° C. for 20 minutes. At that temperature, aqueous ammonia (29%, 30 ml), ammonium chloride (4.5 g), and an aqueous hydrogen peroxide solution (30%, 12 ml) were added in this order, and the mixture was stirred at room temperature for 2 hours. Saturated sodium thiosulfate, acetic acid and ethyl acetate were added, and the mixture was washed with saturated brine. The ethyl acetate layer obtained upon filtration through silica gel was concentrated under reduced pressure. The resulting residue was treated in the same manner as in Example B231 to obtain the title compound (31.3 mg).

来源