반응 #1994238

반응 방정식

oxybutynin hydrochloride

→

Oxybutynin

용매

water

반응 조건

후처리

1. 1
   workup.ADDITIONslowly adding 1586 g of AMBERLITE™
2. 2
   workup.ADDITIONThe dispersion was mixed for 4 hours
3. 3
   기타before decanting the supernatant
4. 4
   기타The wet resin complex was then dried in a VWR™ convention oven
5. 5
   workup.ADDITIONKOLLICOAT™ SR-30D polymer system (540 g) was then slowly added to the wet resin complex in a Hobart type mixer (Kitchen Aid)
6. 6
   기타to form a uniform mass
7. 7
   기타The wet mass was again dried in a 50° C
8. 8
   기타The semi-dried granules were then milled through a 40 mesh screen
9. 9
   기타continued drying at 50° C. until the moisture content
10. 10
    기타The dried granules were then milled through a 40 mesh screen

실험 절차

The Oxybutynin Resin Complex was prepared by first dissolving 300 g of oxybutynin hydrochloride in 8 L of purified water, and then slowly adding 1586 g of AMBERLITE™ IRP-69 resin with continuous mixing. The pH was adjusted to 3.9. The dispersion was mixed for 4 hours, and upon completion, allowed to settle before decanting the supernatant. The slurring/decanting process was repeated twice with sufficient amounts of purified water. The wet resin complex was then dried in a VWR™ convention oven maintained at 50° C. until moisture content was about 25%. KOLLICOAT™ SR-30D polymer system (540 g) was then slowly added to the wet resin complex in a Hobart type mixer (Kitchen Aid) to form a uniform mass. The wet mass was again dried in a 50° C. VWR™ convention oven to the moisture content about 25%. The semi-dried granules were then milled through a 40 mesh screen using CO-MIL™ and continued drying at 50° C. until the moisture content was between 3-7%. The dried granules were then milled through a 40 mesh screen using CO-MILT™.

출처