반응 #1884958
ord-21e9a5da84824cadaf1504fcdf95c23a
반응 방정식
반응 조건
실험 절차
Various Octreotide microspheres were prepared from a clear dispersed phase containing the polymer, octreotide, methylene chloride (DCM) and methanol. Octreotide acetate was obtained from Polypeptide Laboratories or Peninsula Lab. Polymer concentration was varied for the batches to obtain appropriate particle size and also to obtain efficient drug load. Methanol (MeOH) to DCM ratio was increased while making higher drug load batches to get a clear dispersed phase. The continuous phase was a 0.35% PVA solution in all preparations. In a typical preparation, CP was taken in a beaker and stirred using a Silverson homogenizer (standard emulsor screen). To the stirring CP, the dispersed phase was added just below the Silverson head using a laboratory syringe with a bent needle. After 30 sec to 1 minute homogenization, the entire suspension was transferred into a 3 liter Applikon bioreactor for solvent removal. The solvent removal from the microsphere was achieved by initial CP replacement with water followed by heating the suspension at 40° C. along with air sweep. After the solvent removal the microspheres were collected on a filter membrane, washed and dried under vacuum.