반응 #1269809

ord-3836beaa1ecd436c9444c57d2330e7bf

반응 방정식

C#CCCO
3-butyn-1-ol
C1CCC(OC2CCCCO2)OC1
Tetrahydropyranyl ether
C1=COCCC1
3,4-Dihydro-2H-pyran
Cc1ccc(S(=O)(=O)O)cc1.c1ccncc1
pyridine p-toluenesulfonate
C#CCCO
3-butyn-1-ol
COC(=O)/C=C(\CCO)C(C)C
Methyl (E)-3-(2-hydroxyethyl)-4-methyl-2-pentenoate

반응 조건

온도
0°CELSIUS
상세 조건
See reaction.notes.procedure_details.

후처리

  1. 1
    온도maintaining the temperature between approximately 0 and approximately 5° C
  2. 2
    온도warmed to about 25° C.
  3. 3
    workup.STIRRINGstirred for additional about 2 h
  4. 4
    기타transferred to a separatory funnel
  5. 5
    기타The layers were separated
  6. 6
    추출the aqueous phase was extracted with methylene chloride
  7. 7
    세척Combined organic extracts were washed with NaHCO3 (aq), brine
  8. 8
    건조dried with Na2SO4 (anhydrous)
  9. 9
    workup.DISTILLATIONDistillation
  10. 10
    기타produced approximately 23 g of THPO-protected 3-butyn-1-ol with a by of about 50-55° C./4 mm Hg with GC-MS (m/z, relative intensity)

실험 절차

Methyl (E)-3-(2-hydroxyethyl)-4-methyl-2-pentenoate was synthesized according to scheme shown in FIG. 1. Unless otherwise specified all reagents and solvents were purchased from Aldrich Chemical Co. Tetrahydropyranyl ether (THP) protection of 3-butyn-1-ol was conducted following a procedure by Rama Rao et al. (1986). A solution of 3-butyn-1-ol (approximately 14.0 g, approximately 0.2 mol) in methylene chloride (approximately 75 ml, dried by distillation from CaH2) was placed in a flask under N2. The mixture was cooled to approximately 0° C., and pyridine p-toluenesulfonate (approximately 0.28 g) was added. 3,4-Dihydro-2H-pyran (about 20.1 ml) was added via a dropping funnel maintaining the temperature between approximately 0 and approximately 5° C. The mixture was stirred at this temperature for about 1 h, then warmed to about 25° C. and stirred for additional about 2 h. Thin layer chromatography (silica gel, hexanes/ethyl acetate, approximately 3:1) showed that the reaction was complete. The reaction mixture was taken into cold water (approximately 70 ml) and transferred to a separatory funnel. The layers were separated and the aqueous phase was extracted with methylene chloride. Combined organic extracts were washed with NaHCO3 (aq), brine, and dried with Na2SO4 (anhydrous). Distillation produced approximately 23 g of THPO-protected 3-butyn-1-ol with a by of about 50-55° C./4 mm Hg with GC-MS (m/z, relative intensity): 153 (2, M+-1), 99 (9), 85 (100), 79 (9), 67 (20), 53 (42), 41 (33). The mass spectrum matched the spectrum presented in the NIST MS library for this intermediate compound.

출처

DOI: 10.6084/m9.figshare.5104873.v1특허: US08663621B2uspto-grants-2014_03