Réaction #640544
ord-e68aaf2461f3473e9441470ffea7f665
Équation de réaction
Solvants
Conditions de réaction
Traitement
- 1workup.ADDITIONwas added to the flask
- 2Températurethe resulting slurry was cooled below 15° C. in an ice bath
- 3workup.STIRRINGAfter stirring at 0-5° C. for 30 min.
- 4AutreReaction
- 5workup.WAITwas left
- 6workup.STIRRINGstirring for 30 min
- 7ExtractionThe reaction mixture was extracted with diethyl ether (3×)
- 8ConcentrationThe organic extracts were concentrated to approximately one-fourth the original volume
- 9Extractionextracted with 25 mL 1N sodium hydroxide solution
- 10AutreThe layers were separated
- 11ExtractionThe acidified aqueous layer was then extracted with diethyl ether (3×)
- 12Séchagedried (MgSO4)
- 13Concentrationconcentrated
- 14Autreto yield a reddish-colored oil
- 15AutrePurification by flash chromatography on silica gel using a gradient of 0-7% methanol/methylene chloride
Mode opératoire
A one-necked 100 mL round-bottomed flask (magnetic stirring) was charged with 1.0 gram (6.6 mM) 3-amino-2-methylbenzoic acid. A warm mixture of 2.3 mL conc. sulfuric acid in 4.3 mL water was added to the flask, the resulting slurry was cooled below 15° C. in an ice bath, and 6.6 grams of ice was added. The reaction mixture was treated via subsurface addition with a solution of 0.6 gram (8.6 mM) sodium nitrite in 6.6 mL ice water with the reaction temperature maintained at 0-5° C. during the addition. After stirring at 0-5° C. for 30 min., a few crystals of urea were added to decompose the excess nitrite. The reaction mixture was then poured into a room temperature solution of 23.8 grams (102.3 mM) copper (II) nitrate hemipentahydrate in 200 mL water. With vigorous stirring, the reaction mixture was treated with 0.9 gram (6.0 mM) copper (I) oxide. The reaction mixture foamed and changed from turquoise blue to dark green in color. Reaction was left stirring for 30 min. The reaction mixture was extracted with diethyl ether (3×), and the organic extracts were combined. The organic extracts were concentrated to approximately one-fourth the original volume, then extracted with 25 mL 1N sodium hydroxide solution. The layers were separated, and the dark-red aqueous layer was acidified to pH=2 using 1N hydrochloric acid solution. The acidified aqueous layer was then extracted with diethyl ether (3×), and the ether extracts were combined, dried (MgSO4), and concentrated to yield a reddish-colored oil. Purification by flash chromatography on silica gel using a gradient of 0-7% methanol/methylene chloride afforded 0.39 grams (36%) of a yellow solid.