Reaktion #1365700

Reaktionsgleichung

NaOH

LiAlH4

(+/−) trans-3-ethoxycarbonyl-4-(4′-fluorophenyl)-N-methyl-piperidine-2,6-dione

toluene

→

(+/−) trans-4-(4′-fluorophenyl)-3-hydroxymethyl-N-methylpiperidine

Lösungsmittel

toluene THF

THF

H2O

Water

Reaktionsbedingungen

Aufarbeitung

1. 1
   workup.ADDITIONAfter addition
2. 2
   SonstigeAfter 30 minutes at room temperature reaction
3. 3
   Temperaturwas heated to >40° C. for 2 hr
4. 4
   SonstigeReaction
5. 5
   Temperaturwas then cooled to <5° C.
6. 6
   Sonstigethe temperature below 15° C
7. 7
   SonstigeThe solid inorganic salts were removed by filtration
8. 8
   WaschenThese solids were washed with additional THF or toluene
9. 9
   EinengenThe filtered solution was then concentrated

Vorschrift

To a cooled solution of LiAlH4 (0.22 mol) in toluene/THF under argon was added (+/−) trans-3-ethoxycarbonyl-4-(4′-fluorophenyl)-N-methyl-piperidine-2,6-dione (0.083 mol) in THF holding the temperature below 15° C. After addition was complete, the reaction was allowed to warm to room temperature. After 30 minutes at room temperature reaction was heated to >40° C. for 2 hr. Reaction was then cooled to <5° C. and toluene (50 ml) was added. Water (9 ml) was then added slowly holding the temperature below 15° C. Additional H2O or aqueous NaOH was used as necessary. The solid inorganic salts were removed by filtration. These solids were washed with additional THF or toluene. The filtered solution was then concentrated to give (+/−) trans-4-(4′-fluorophenyl)-3-hydroxymethyl-N-methylpiperidine in higher yield (but similar impurity profile) as with NaAlH4 as shown by HPLC analysis. The product can be recovered by standard procedures such as trituration with a less polar solvent.

Quelle