Reaktion #1269809

Reaktionsgleichung

3-butyn-1-ol

Tetrahydropyranyl ether

3,4-Dihydro-2H-pyran

pyridine p-toluenesulfonate

3-butyn-1-ol

→

Methyl (E)-3-(2-hydroxyethyl)-4-methyl-2-pentenoate

Lösungsmittel

methylene chloride

water

Reaktionsbedingungen

Aufarbeitung

1. 1
   Temperaturmaintaining the temperature between approximately 0 and approximately 5° C
2. 2
   Temperaturwarmed to about 25° C.
3. 3
   workup.STIRRINGstirred for additional about 2 h
4. 4
   Sonstigetransferred to a separatory funnel
5. 5
   SonstigeThe layers were separated
6. 6
   Extraktionthe aqueous phase was extracted with methylene chloride
7. 7
   WaschenCombined organic extracts were washed with NaHCO3 (aq), brine
8. 8
   Trocknendried with Na2SO4 (anhydrous)
9. 9
   workup.DISTILLATIONDistillation
10. 10
    Sonstigeproduced approximately 23 g of THPO-protected 3-butyn-1-ol with a by of about 50-55° C./4 mm Hg with GC-MS (m/z, relative intensity)

Vorschrift

Methyl (E)-3-(2-hydroxyethyl)-4-methyl-2-pentenoate was synthesized according to scheme shown in FIG. 1. Unless otherwise specified all reagents and solvents were purchased from Aldrich Chemical Co. Tetrahydropyranyl ether (THP) protection of 3-butyn-1-ol was conducted following a procedure by Rama Rao et al. (1986). A solution of 3-butyn-1-ol (approximately 14.0 g, approximately 0.2 mol) in methylene chloride (approximately 75 ml, dried by distillation from CaH2) was placed in a flask under N2. The mixture was cooled to approximately 0° C., and pyridine p-toluenesulfonate (approximately 0.28 g) was added. 3,4-Dihydro-2H-pyran (about 20.1 ml) was added via a dropping funnel maintaining the temperature between approximately 0 and approximately 5° C. The mixture was stirred at this temperature for about 1 h, then warmed to about 25° C. and stirred for additional about 2 h. Thin layer chromatography (silica gel, hexanes/ethyl acetate, approximately 3:1) showed that the reaction was complete. The reaction mixture was taken into cold water (approximately 70 ml) and transferred to a separatory funnel. The layers were separated and the aqueous phase was extracted with methylene chloride. Combined organic extracts were washed with NaHCO3 (aq), brine, and dried with Na2SO4 (anhydrous). Distillation produced approximately 23 g of THPO-protected 3-butyn-1-ol with a by of about 50-55° C./4 mm Hg with GC-MS (m/z, relative intensity): 153 (2, M+-1), 99 (9), 85 (100), 79 (9), 67 (20), 53 (42), 41 (33). The mass spectrum matched the spectrum presented in the NIST MS library for this intermediate compound.

Quelle